OpenWrt (Open Wireless Router) is an open-source Linux OS for developing custom operating systems targeting embedded systems. Today’s article focuses on all things OpenWrt x86. If you have an embedded system or router, it’s better to use the operating system as it has many great features. I assume if I can even get that far that I'll need to then script my own modem at commands as I wouldn't expect the dd-wrt user interface to have any of that.OpenWrt is easy to set up and enables you to maximize your routers’ capabilities beyond what’s availed by its firmware. If I wanted to use an official build to get my lan card working, which one? And then how hard would it be for me to add emm7455 4g modem drivers. squashfs verses rootfs verses ext4 verses others. Thus I don't really understand "snapshot"? As far as I knew, I was working with a disk image that once restored to a drive, was capable of upgrading etc, just like any official dd-wrt x86 build / supported linux distribution. I simply used rufus to write out the x86 goldenorb disk image to a usb that I boot off it. Since goldenorb is open-wrt, with 4g modem capabilities, I thought this the forum to ask, especially since the rooter folks don't even have an official forum, but I suppose that's like asking an ubuntu question in the debian forums. For my friends, the version of open-wrt that I'm trying to use is in fact the latest x86 version of goldenorb found here. Sorry for wasting everyone's time, as this wouldn't even be the right forum to post such a question. Well looks like I'm stuck for not fully understanding how things get screwy with forks. Then once the drivers installed, is a reboot going to be enough? Or is everything I've read completely wrong, as all that stuff I've read is about atheros wifi? Opkg install kmod-ath8151 doesn't seem to work. Both Broadcom adapters works as expected, but I'…Īnd a few other places, as well as searching the forums here, I'm still not sure howto use opkg to setup the driver for my atheros ar8151 lan card. I inserted Gigabyte GC-WB300D in a PCIe ×16 slot (just because I want it as near to the CPU as possible and not to slow down anything on south bridge like those two LAN adapters). The board (Gigabyte 955X Royal) has two Broadcom LAN adapters, one I want to use as WAN, second one as LAN. I'm trying to setup OpenWRT (latest 18.06.2) on an older hardware with Pentium 4 EE (don't ask why and please do not concern about power requirements). Atheros AR9462 on x86 as an AP - can not get it to work at all Network and Wireless Configuration
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |